Tape Spindle and Zip Tie Bench Caddy

Bench caddy that keeps a tape roll and a bundle of zip ties in one fixed spot on the bench. A 24 mm spindle holds a roll with a 25 mm core. A serrated tear bar runs along the front edge so tape can be pulled across the teeth and torn. A block on the right has three slots for zip ties up to 90 mm long.

Specs

• Base: 150 × 100 × 5 mm plate with 1.5 mm chamfered edges
• Spindle: 24 mm diameter, about 46 mm tall, with a 34 mm foot and a 30 mm top flange. Sized for a 25 mm core with 1 mm clearance.
• Tear bar: 70 mm long, 4 mm thick wall with 14 serrated teeth. It sits along the front (-Y) edge, beside the spindle.
• Tie trough: 34 × 100 mm block, 28 mm tall, with three 6 mm wide slots, each 90 mm long, in a row across X.
• Overall height: about 54 mm, measured at the top of the spindle flange.
• Material: PLA or PETG. Print flat on the base with no supports.

Notes

• Fit has not been tested against a physical roll. If the roll is tight on the spindle, reduce the spindle diameter slightly.
• Slot width suits standard narrow zip ties. Wider ties need wider slots.