60mm Arc Reactor LED Ring
Created today
Description
Circular mounting ring for standard 5mm LEDs. Sized with a 60mm outer diameter and a 48mm pitch circle. Features a continuous recessed channel on the rear face to simplify wire routing and soldering, plus a stepped front lip to seat a custom diffuser plate.
- Outer Diameter: 60.0 mm
- Inner Diameter: 36.0 mm
- Thickness: 5.0 mm
- LED Fitment: 5x 5.2mm bores (72° spacing)
- Rear Recesses: 6.2mm flange countersinks with an 8mm wide wire track
- Front Groove: 1.0 mm deep, accommodates a 56mm OD diffuser
Images
More like this
Explore more in Automotive, RC & Hobby →
60mm RV Outlet Weather Cover
A heavy-duty, print-in-place weather cover designed for RV and camper electrical outlets. This cover features a robust 60x60mm footprint with an uninterrupted 40x40mm rear passthrough, replacing standard multi-hole mounts with a single unified channel. Specifications Overall Dimensions: 60 x 60 x 20 mm Front Chamber: 48 x 48 mm (17 mm depth) Rear Passthrough: 40 x 40 mm (centered) Hinge Mechanism: Integrated 2.5 mm axis knuckle hinge (100° range) Weather Resistance: Geometry-based labyrinth seal, bottom drip edge, and top hinge shield Tolerances: Pre-calculated 0.3 - 0.5 mm mechanical clearances for print-in-place operation
Lego piece for wagon door runner with thinner teeth bit slightly smaller
Wagon door runner to replace 3 off 15208 bricks Version with slightly too large slope
Sweeping Dollhouse Window Slide
A large 3D-printable playground slide designed to mount securely into a 90 mm window frame, sized for 1:6 scale dolls. The track follows a single smooth clockwise sweep out and away from the dollhouse, transitioning cleanly to the floor. Broad Descent: Uses a smooth Bezier sweep to drop 460 mm without looping or reversing direction. Upright Geometry: The track remains perfectly level across its width from top to bottom. Window Mount: Features a squared notch that drops cleanly over a standard lower window edge.
50mm Armed Safety Kart
A modified safety kart chassis scaled to exactly 50 by 20 by 20 millimeters (5x2x2 centimeters). Fits standard FDM build volumes and layer resolutions. Replaces the 5mm micro variant. The machine gun barrels and safety structures are now large enough to resolve cleanly on a standard 0.4mm nozzle. Check your slicer preview to ensure the top-mounted magazines and barrel steps bridge properly.
Minifig Gravity Hammer
An overpowered sci-fi gravity hammer designed specifically for standard building block minifigures. Perfect Fit: The main shaft is modeled at 3.2mm, allowing a standard minifigure hand to clip onto it easily. Support-Free: The entire weapon is oriented to print perfectly flat on the build plate. Details: Features a thickened grip area, a spiked pommel, and glowing energy nodes on the primary striking block.
OO Scale Low-Relief Georgian HouseKit
A low-relief flat-pack Georgian building scaled for OO gauge (4mm to the foot). The kit prints flat and features inner 45-degree miters on the walls for clean 90-degree outer corners. Remix Hooks Scale: Set up for OO (1:76), but scales down to N or up to O nicely if you check your tolerances on the drop-in parts. Clearances: The windows and doors are designed with a slight undersize to allow for a coat of paint before dropping them in. Roofs: Sized at 35mm deep to give a 5mm overhang past the 30mm side walls, and long enough to meet at the ridge and clear the eaves. They feature a stepped slate/tile texture.