Description
A utilitarian stopper milled down to exact measurements. The main barrel drops directly into the aperture, while a slight oversized collar keeps it from falling through.
Design notes:
- Main body: 48.6 mm diameter (152.7 mm circumference)
- Collar lip: 51.2 mm diameter (160.8 mm circumference)
- Total height: 20 mm (18 mm body, 2 mm lip)
Images
More like this
Explore more in Workshop & Tools →
Grey I-Shaped Bracket
A custom I-shaped bracket featuring a 36x50x40 mm outer profile and 15.5 mm side cutouts. Designed with rounded edges for a clean finish and smooth handling. Overall Dimensions: 36 mm wide, 50 mm deep, 40 mm tall Cutouts: 15.5 mm high spacing on the sides Features: 3 mm edge rounding Material: Fits standard filaments perfectly
5mm Solid Mounting Pin
A solid, non-threaded structural pin designed for aligning and securing aluminum frame extrusions. Modeled with an undersized shaft to account for dimensional expansion during printing. Shaft Diameter: 4.9mm (nominal 5mm fit) Shaft Length: 32mm Head Thickness: 2mm Head Diameter: 9.5mm Note: The 100% infill requirement must be configured in your slicer settings prior to printing to ensure the part achieves maximum shear strength.
17mm Retaining Wedge Fork
A wedge-profile retaining fork designed to slide radially onto a 17mm shaft or groove without flexing. It replaces standard wrap-around snap rings or C-clips where rigid materials prevent a snap-fit. Dimensions Bore / Slot Width: 17mm (straight slide-on clearance) Outer Diameter: 23mm Thickness: Ramps smoothly from 2.9mm at the open tines to 3.0mm at the closed back.
Verbindungsstück l60mm,d60mm
A straight, uniform hollow pipe designed for structural use or fluid routing. The bore is continuous and centered, producing a robust 2 mm wall suitable for standard FDM printing. Outer Diameter: 60 mm Inner Diameter: 56 mm Length: 60 mm Wall Thickness: 2 mm Orient vertically on the build plate to print without supports.
Zauberstab Verschluss 2.0
Zweiteiliger, hohler zylindrischer Testkörper zur Prüfung von FDM-Toleranzen. Beide Teile verfügen über eine geschlossene Außenwand und schließen bündig ab. Feste Abmessungen: Außen 30.8 mm, Innen 21.8 mm Mindestwandstärke: 1.5 mm im kritischen Bereich der Nuten Mechanismus: Bajonettverschluss mit Arretierungsnocke gegen unbeabsichtigtes Öffnen Druckbar: Ohne Stützstrukturen, flach auf dem Druckbett positioniert
60mm OD Flanged 45° Pipe
60mm outer diameter flanged pipe with a 45-degree elbow. Features a continuous 56mm inner bore with a 2mm wall thickness. The 100mm OD flange is positioned exactly 30mm from the base and runs 3mm thick. Check your clamp or mating collar against the flange thickness and 100mm outer diameter. No mounting holes are drilled; this part is built for bonded or slip-fit assemblies where the 56mm internal passage must remain entirely unobstructed.