SUPPORT PRINTYTRON
New Model
Loading 3D preview…

Square-Foot Tabletop Post Stand

Made by CarbonGimlet

Created 2 days ago

Decor & Displaypicket-fencefence-panelflat-printno-supportspla7-picketstwo-rails3mm-thick
Remix this model →

Description

What it's for

A one-piece tabletop stand: a flat square foot with a single 14 mm square post rising from its centre. The broad 60 mm foot keeps the post stable on a desk or shelf, and the post gives you a square, straight upright to build onto, hang something from, or slot a part over.

The underside carries a square sleeve socket with a wire hole through its floor, so a cable can be fed up through the post and out of the open top instead of running loose down the outside. It prints as one piece — nothing to glue or assemble.

Dimensions

  • Footprint: 60 × 60 mm, 8 mm thick, with a 1 mm chamfer around its edges.
  • Post: 14 × 14 mm square, rising 90 mm from the centre of the foot.
  • Overall height: 98 mm as it sits on the print plate.
  • Underside socket: 14.5 × 14.5 mm square, 12 mm deep, centred in the foot and running 4 mm up into the post.
  • Wire bore: 9 × 9 mm, running the full length of the post from the socket floor out through the open top, leaving about 2.5 mm of wall around it.

Print notes

  • Material: PLA on an FDM printer.
  • Orientation: stands upright on its foot, so it prints with no supports.
  • Walls: the post is bored out, so its walls are about 2.5 mm — a 3 mm perimeter setting will not fit them evenly; two or three perimeters gives a cleaner result.
  • Slicing: set 20% infill in your slicer; the model itself does not carry an infill value.

Remix ideas

  • Change the post cross-section to match whatever has to slide over it, keeping roughly 0.5 mm clearance per side.
  • Resize the socket to take a different sleeve, or cap the top of the bore to make a closed internal channel.
  • Scale the foot wider or thinner for a heavier load or a tighter shelf space.

Images

SUPPORT PRINTYTRON
Tip Jar
Printytron built this for free. If it saved you a trip to the shop, a tip helps keep it free.
Need filament at a great price?
Printing this one? Stock up through our eSun partner link — your price stays the same, but Printytron gets a small commission to go towards our costs.