SUPPORT PRINTYTRON
New Model
Loading 3D preview…

Bud Vase Holding Glass Test Tube

Made by a Guest

Created 2 days ago

Decor & Displayvasebud-vasetest-tubetwistedfacetedno-supportsspiralsingle-stem
Remix this model →

Description

A bare test tube tips over, and a printed vase can't hold water on its own. This bud vase gives a 15 mm glass test-tube liner a heavy, upright body. The liner carries the water and the vase carries the liner, so a single stem stays put.

The eight facets twist a quarter turn from base to mouth, which gives the ridges edges that catch light along the full height.

Numbers that matter

  • Bore: 16 mm diameter, for a standard 15 mm glass tube with 1 mm of clearance
  • Bore depth: about 138 mm, above a 12 mm solid floor
  • Height: 150 mm
  • Width: 50 mm across the flats at the base
  • Mouth: 1.5 mm lead-in chamfer so the tube slides in without catching

Printing

  • Prints upright with no supports. The twist is gentle enough that each layer sits on the one below.
  • Use a 0.2 mm layer height or finer so the ridges stay crisp.
  • The printed body is not watertight. Keep water inside the glass tube only.
  • Measure your tube before printing. Tubes longer than about 138 mm will stick out of the mouth.

Photos

Technical views

SUPPORT PRINTYTRON
Tip Jar
Printytron built this for free. If it saved you a trip to the shop, a tip helps keep it free.
Need filament at a great price?
Printing this one? Stock up through our eSun partner link — your price stays the same, but Printytron gets a small commission to go towards our costs.
Square-Foot Tabletop Post Stand

Square-Foot Tabletop Post Stand

What it's for A one-piece tabletop stand: a flat square foot with a single 14 mm square post rising from its centre. The broad 60 mm foot keeps the post stable on a desk or shelf, and the post gives you a square, straight upright to build onto, hang something from, or slot a part over. The underside carries a square sleeve socket with a wire hole through its floor, so a cable can be fed up through the post and out of the open top instead of running loose down the outside. It prints as one piece — nothing to glue or assemble. Dimensions Footprint: 60 × 60 mm, 8 mm thick, with a 1 mm chamfer around its edges. Post: 14 × 14 mm square, rising 90 mm from the centre of the foot. Overall height: 98 mm as it sits on the print plate. Underside socket: 14.5 × 14.5 mm square, 12 mm deep, centred in the foot and running 4 mm up into the post. Wire bore: 9 × 9 mm, running the full length of the post from the socket floor out through the open top, leaving about 2.5 mm of wall around it. Print notes Material: PLA on an FDM printer. Orientation: stands upright on its foot, so it prints with no supports. Walls: the post is bored out, so its walls are about 2.5 mm — a 3 mm perimeter setting will not fit them evenly; two or three perimeters gives a cleaner result. Slicing: set 20% infill in your slicer; the model itself does not carry an infill value. Remix ideas Change the post cross-section to match whatever has to slide over it, keeping roughly 0.5 mm clearance per side. Resize the socket to take a different sleeve, or cap the top of the bore to make a closed internal channel. Scale the foot wider or thinner for a heavier load or a tighter shelf space.

CarbonGimlet · 2 days agoRemix →