5mm Solid Mounting Pin
Created today
Description
A solid, non-threaded structural pin designed for aligning and securing aluminum frame extrusions. Modeled with an undersized shaft to account for dimensional expansion during printing.
- Shaft Diameter: 4.9mm (nominal 5mm fit)
- Shaft Length: 32mm
- Head Thickness: 2mm
- Head Diameter: 9.5mm
Note: The 100% infill requirement must be configured in your slicer settings prior to printing to ensure the part achieves maximum shear strength.
Photos
Technical views
More like this
Explore more in Workshop & Tools →
5mm Round Head Pin
A plain round-headed hardware blank, sized to match standard 5mm metric fasteners but stripped of threads and drive features. Modification Points Dimensions: 5mm shaft diameter, 32mm shaft length (35mm overall). Tolerances: Prints exactly at 5mm. Scale the shaft down slightly (or drill your target hole) if you need a slip fit. Derivatives: Easy to modify into a clevis pin by adding a cross-hole near the tip, or cut a slot across the top to return it to a flathead.
17mm Retaining Wedge Fork
A wedge-profile retaining fork designed to slide radially onto a 17mm shaft or groove without flexing. It replaces standard wrap-around snap rings or C-clips where rigid materials prevent a snap-fit. Dimensions Bore / Slot Width: 17mm (straight slide-on clearance) Outer Diameter: 23mm Thickness: Ramps smoothly from 2.9mm at the open tines to 3.0mm at the closed back.
Tee-Spanner — Offset Bracket
A sturdy, precision-measured stepped T-bracket designed to join or space components on multiple planes. The solid central pillar provides a heavy-duty connection between the base plate and the cross piece. Dimensions Base Plate: 4.5" × 1" × 0.25" Cross Piece: 2.6" × 0.6" × 0.19" Overall Offset: 0.78" top-to-top (0.59" clearance between plates) Mounting Holes: 0.27" diameter, spaced 2" apart Features Stepped dual-plane geometry Print-ready filleted outer corners Heavy center union block for shear strength
Verbindungsstück l60mm,d60mm
A straight, uniform hollow pipe designed for structural use or fluid routing. The bore is continuous and centered, producing a robust 2 mm wall suitable for standard FDM printing. Outer Diameter: 60 mm Inner Diameter: 56 mm Length: 60 mm Wall Thickness: 2 mm Orient vertically on the build plate to print without supports.
Rounded Square Mounting Plate
A heavy-duty square spacer plate with a large central opening. The design features thick, continuous outer walls and uniformly rounded edges to prevent snagging and distribute load evenly. Features: 110 mm square footprint with 35 mm depth 100 mm central through-hole 20 mm radius on all four outer corners Flat bottom profile for easy, support-free printing
60mm OD Flanged 45° Pipe
60mm outer diameter flanged pipe with a 45-degree elbow. Features a continuous 56mm inner bore with a 2mm wall thickness. The 100mm OD flange is positioned exactly 30mm from the base and runs 3mm thick. Check your clamp or mating collar against the flange thickness and 100mm outer diameter. No mounting holes are drilled; this part is built for bonded or slip-fit assemblies where the 56mm internal passage must remain entirely unobstructed.