Description
A heavy-duty cylindrical ring, measuring exactly 115mm across with a 65mm bore. Built straight and solid, ready to act as a substantial standoff, collar, or structural spacer.
Dimensions
- Outer Diameter: 115 mm
- Inner Diameter: 65 mm
- Height: 30 mm
- Wall Thickness: 25 mm
Images
More like this
Explore more in Workshop & Tools →
7.1mm Bore Spacer Tube
Plain sleeve with a 9mm outer diameter and a 7.1mm through-bore. Length: 40mm Wall thickness: 0.95mm Measure the shaft or bolt this is going over before you run it. 7.1mm is a specific inside dimension, and FDM shrinkage usually eats a fraction of a millimeter on inner bores. With only a 0.95mm wall, there's not much material left to drill out if it runs tight.
5mm Solid Mounting Pin
A solid, non-threaded structural pin designed for aligning and securing aluminum frame extrusions. Modeled with an undersized shaft to account for dimensional expansion during printing. Shaft Diameter: 4.9mm (nominal 5mm fit) Shaft Length: 32mm Head Thickness: 2mm Head Diameter: 9.5mm Note: The 100% infill requirement must be configured in your slicer settings prior to printing to ensure the part achieves maximum shear strength.
Verbindungsstück l60mm,d60mm
A straight, uniform hollow pipe designed for structural use or fluid routing. The bore is continuous and centered, producing a robust 2 mm wall suitable for standard FDM printing. Outer Diameter: 60 mm Inner Diameter: 56 mm Length: 60 mm Wall Thickness: 2 mm Orient vertically on the build plate to print without supports.
Rounded Square Mounting Plate
A heavy-duty square spacer plate with a large central opening. The design features thick, continuous outer walls and uniformly rounded edges to prevent snagging and distribute load evenly. Features: 110 mm square footprint with 35 mm depth 100 mm central through-hole 20 mm radius on all four outer corners Flat bottom profile for easy, support-free printing
Zauberstab Verschluss 2.0
Zweiteiliger, hohler zylindrischer Testkörper zur Prüfung von FDM-Toleranzen. Beide Teile verfügen über eine geschlossene Außenwand und schließen bündig ab. Feste Abmessungen: Außen 30.8 mm, Innen 21.8 mm Mindestwandstärke: 1.5 mm im kritischen Bereich der Nuten Mechanismus: Bajonettverschluss mit Arretierungsnocke gegen unbeabsichtigtes Öffnen Druckbar: Ohne Stützstrukturen, flach auf dem Druckbett positioniert
60mm OD Flanged 45° Pipe
60mm outer diameter flanged pipe with a 45-degree elbow. Features a continuous 56mm inner bore with a 2mm wall thickness. The 100mm OD flange is positioned exactly 30mm from the base and runs 3mm thick. Check your clamp or mating collar against the flange thickness and 100mm outer diameter. No mounting holes are drilled; this part is built for bonded or slip-fit assemblies where the 56mm internal passage must remain entirely unobstructed.