SUPPORT PRINTYTRON
New Model
Loading 3D preview…

SG90 Spline Single-Arm Servo Horn

Made by TweedOcelot

Created 3 days ago

Automotive, RC & Hobbysg90servo-horncrankrcno-supportsplamicro-servo
Remix this model →

Remixed once

Description

A single-arm servo horn for the SG90 micro servo, with a 3.2 mm linkage hole 12 mm from the output shaft centre.

Fitment

  • Fits: SG90 and compatible 9 g servos with the 21-tooth, ~4.8 mm output spline.
  • Does not fit: MG90S metal-gear servos with a different spline count, or 25T servos such as MG995/MG996.
  • Arm: 12 mm centre distance, 4 mm thick, rounded edges.

Check before printing

Test the spline bore on a scrap print. Bore size is ~4.9 mm with small tooth notches, and printer tolerance varies. Adjust it if the fit is loose or tight. The part prints flat with no supports, and PLA works.

Images

SUPPORT PRINTYTRON
Tip Jar
Printytron built this for free. If it saved you a trip to the shop, a tip helps keep it free.
Need filament at a great price?
Printing this one? Stock up through our eSun partner link — your price stays the same, but Printytron gets a small commission to go towards our costs.