SUPPORT PRINTYTRON
New Model
Loading 3D preview…

Cali-Burrito Chibi

Made by a Guest

Created 3 months ago

Decor & Displaycali-catcalibration-testlow-polydonkeychibino-supports
Remix this model →

Description

Un burro de calibración estilo low-poly. Ideal para comprobar tolerancias y voladizos en impresiones rápidas, con el innegable encanto geométrico de las clásicas piezas de calibración pero en forma de burrito.

Detalles de impresión

  • Ojos y nariz: Grabados a apenas tres capas de profundidad (0.6mm), lo justo para crear sombra.
  • Patas y orejas: Construcción recta biselada para evitar la necesidad de soportes.
  • Base: Completamente plana sobre el origen.

Images

SUPPORT PRINTYTRON
Tip Jar
Printytron built this for free. If it saved you a trip to the shop, a tip helps keep it free.
Need filament at a great price?
Printing this one? Stock up through our eSun partner link — your price stays the same, but Printytron gets a small commission to go towards our costs.
Square-Foot Tabletop Post Stand

Square-Foot Tabletop Post Stand

What it's for A one-piece tabletop stand: a flat square foot with a single 14 mm square post rising from its centre. The broad 60 mm foot keeps the post stable on a desk or shelf, and the post gives you a square, straight upright to build onto, hang something from, or slot a part over. The underside carries a square sleeve socket with a wire hole through its floor, so a cable can be fed up through the post and out of the open top instead of running loose down the outside. It prints as one piece — nothing to glue or assemble. Dimensions Footprint: 60 × 60 mm, 8 mm thick, with a 1 mm chamfer around its edges. Post: 14 × 14 mm square, rising 90 mm from the centre of the foot. Overall height: 98 mm as it sits on the print plate. Underside socket: 14.5 × 14.5 mm square, 12 mm deep, centred in the foot and running 4 mm up into the post. Wire bore: 9 × 9 mm, running the full length of the post from the socket floor out through the open top, leaving about 2.5 mm of wall around it. Print notes Material: PLA on an FDM printer. Orientation: stands upright on its foot, so it prints with no supports. Walls: the post is bored out, so its walls are about 2.5 mm — a 3 mm perimeter setting will not fit them evenly; two or three perimeters gives a cleaner result. Slicing: set 20% infill in your slicer; the model itself does not carry an infill value. Remix ideas Change the post cross-section to match whatever has to slide over it, keeping roughly 0.5 mm clearance per side. Resize the socket to take a different sleeve, or cap the top of the bore to make a closed internal channel. Scale the foot wider or thinner for a heavier load or a tighter shelf space.

CarbonGimlet · 2 days agoRemix →