SUPPORT PRINTYTRON
New Model
Loading 3D preview…

GIVVY — Toploader Display Stand

Made by DatumNarwhal

Created 1 months ago

Decor & Displaypokemontrading-carddisplay-standtoploaderno-supportsprint-in-placeembossed-text
Remix this model →

Description

GIVVY Display Stand brings a bold, architectural frame to your favorite sleeved or toploaded trading cards. The design couples a stable, low-profile sloped base with a prominent vertical backboard, acting as a canvas for the heavy, embossed typography. It's built in a single unyielding piece—ready to anchor a desk or elevate a display case without tipping.

Dimensions

  • Overall Footprint: 105mm wide × 46mm deep
  • Height: 65mm total
  • Card Slot: 90mm long, 5.5mm wide, pitched backward at a gentle 5 degrees for the optimal viewing angle.

Print Notes

  • Prints entirely without supports on its flat base.
  • The raised lettering extends 3mm outward, easily catching overhead lighting for sharp contrast.
  • Consider swapping filaments right at the 65mm Z-height (or painting the raised text) to make the branding pop.

Images

SUPPORT PRINTYTRON
Tip Jar
Printytron built this for free. If it saved you a trip to the shop, a tip helps keep it free.
Need filament at a great price?
Printing this one? Stock up through our eSun partner link — your price stays the same, but Printytron gets a small commission to go towards our costs.
Square-Foot Tabletop Post Stand

Square-Foot Tabletop Post Stand

What it's for A one-piece tabletop stand: a flat square foot with a single 14 mm square post rising from its centre. The broad 60 mm foot keeps the post stable on a desk or shelf, and the post gives you a square, straight upright to build onto, hang something from, or slot a part over. The underside carries a square sleeve socket with a wire hole through its floor, so a cable can be fed up through the post and out of the open top instead of running loose down the outside. It prints as one piece — nothing to glue or assemble. Dimensions Footprint: 60 × 60 mm, 8 mm thick, with a 1 mm chamfer around its edges. Post: 14 × 14 mm square, rising 90 mm from the centre of the foot. Overall height: 98 mm as it sits on the print plate. Underside socket: 14.5 × 14.5 mm square, 12 mm deep, centred in the foot and running 4 mm up into the post. Wire bore: 9 × 9 mm, running the full length of the post from the socket floor out through the open top, leaving about 2.5 mm of wall around it. Print notes Material: PLA on an FDM printer. Orientation: stands upright on its foot, so it prints with no supports. Walls: the post is bored out, so its walls are about 2.5 mm — a 3 mm perimeter setting will not fit them evenly; two or three perimeters gives a cleaner result. Slicing: set 20% infill in your slicer; the model itself does not carry an infill value. Remix ideas Change the post cross-section to match whatever has to slide over it, keeping roughly 0.5 mm clearance per side. Resize the socket to take a different sleeve, or cap the top of the bore to make a closed internal channel. Scale the foot wider or thinner for a heavier load or a tighter shelf space.

CarbonGimlet · 2 days agoRemix →