SUPPORT PRINTYTRON
New Model
Loading 3D preview…

GripRoot — Cross-Hatch Cane Tip

Made by a Guest

Created 4 days ago

Home & Fixturescane-tiptpureplacement-partnon-slipmobility-aidcross-hatch-treadflexibleno-supports
Remix this model →

Description

GripRoot is a replacement cane tip for a 19 mm tube, built for the case where an old tip has worn through and started to clack. A wide 40 mm base spreads the load, a tapered body leads up to a deep socket, and a cross-hatch tread on the underside gives grip on wet floors. The grooves run straight out through the edge of the base, so water has a path to escape instead of pooling under the tip.

Dimensions

  • Base diameter: 40 mm, with a chamfered lower edge
  • Overall height: 31 mm
  • Neck diameter at the top: 29 mm
  • Socket: 19.5 mm inner diameter, 25 mm deep
  • Socket mouth: small flared lead-in to help the tube seat

Tread

  • Cross-hatch grid of grooves, 3 mm wide and 2.5 mm deep
  • 6 mm pitch in both directions
  • Grooves open at the base edge for drainage

Print notes

  • Designed for stiff TPU, printed base-down with no supports needed
  • The 19.5 mm socket against a 19 mm tube gives roughly 0.5 mm of interference, which suits a flexible material
  • Measure the actual tube before printing, since nominal 19 mm tubing often varies slightly
  • Adjust socket diameter or groove depth if a tighter grip or a more aggressive tread is wanted

Photos

Technical views

SUPPORT PRINTYTRON
Tip Jar
Printytron built this for free. If it saved you a trip to the shop, a tip helps keep it free.
Need filament at a great price?
Printing this one? Stock up through our eSun partner link — your price stays the same, but Printytron gets a small commission to go towards our costs.