SUPPORT PRINTYTRON
New Model
Loading 3D preview…

Lucent — Acrylic Spine Stand

Made by EvilStark

Created 3 months ago

Decor & Displayacrylic-standlucite-clipphoto-displayprint-in-placeno-supportsminimalistdisplay-stand
Remix this model →

Description

Lucent is a minimalist C-channel spine designed to hold two 1-inch thick, 4x6 acrylic photo blocks in a vertical stack. Rather than encasing the blocks, it grips them from the back using a continuous tension spine and two tiny retention tabs at the extreme top and bottom, remaining almost completely invisible from the front.

The entire assembly leans back at a subtle 7-degree angle. Because 2 pounds of solid acrylic has a tendency to tip, the clip features an extended, wedge-shaped rear foot that acts as a counter-lever, keeping the stack firmly planted on your desk.

Dimensions

  • Capacity: Holds exactly two 4" x 6" x 1" blocks stacked vertically (8" total height).
  • Clearance: 26.2mm deep slot with a 204.4mm height, allowing the blocks to slide in easily from the side without binding.
  • Footprint: 40mm wide by 75mm deep.

Print notes

When you import this into your slicer, lay it flat on its side. Printing it sideways ensures the layer lines run continuously along the entire length of the spine. If you print it standing upright, the layers will run horizontally, and the leverage of the heavy acrylics will snap the spine across a layer line. Printed flat, it requires zero supports and is essentially unbreakable.

Photos

Technical views

SUPPORT PRINTYTRON
Tip Jar
Printytron built this for free. If it saved you a trip to the shop, a tip helps keep it free.
Need filament at a great price?
Printing this one? Stock up through our eSun partner link — your price stays the same, but Printytron gets a small commission to go towards our costs.
Square-Foot Tabletop Post Stand

Square-Foot Tabletop Post Stand

What it's for A one-piece tabletop stand: a flat square foot with a single 14 mm square post rising from its centre. The broad 60 mm foot keeps the post stable on a desk or shelf, and the post gives you a square, straight upright to build onto, hang something from, or slot a part over. The underside carries a square sleeve socket with a wire hole through its floor, so a cable can be fed up through the post and out of the open top instead of running loose down the outside. It prints as one piece — nothing to glue or assemble. Dimensions Footprint: 60 × 60 mm, 8 mm thick, with a 1 mm chamfer around its edges. Post: 14 × 14 mm square, rising 90 mm from the centre of the foot. Overall height: 98 mm as it sits on the print plate. Underside socket: 14.5 × 14.5 mm square, 12 mm deep, centred in the foot and running 4 mm up into the post. Wire bore: 9 × 9 mm, running the full length of the post from the socket floor out through the open top, leaving about 2.5 mm of wall around it. Print notes Material: PLA on an FDM printer. Orientation: stands upright on its foot, so it prints with no supports. Walls: the post is bored out, so its walls are about 2.5 mm — a 3 mm perimeter setting will not fit them evenly; two or three perimeters gives a cleaner result. Slicing: set 20% infill in your slicer; the model itself does not carry an infill value. Remix ideas Change the post cross-section to match whatever has to slide over it, keeping roughly 0.5 mm clearance per side. Resize the socket to take a different sleeve, or cap the top of the bore to make a closed internal channel. Scale the foot wider or thinner for a heavier load or a tighter shelf space.

CarbonGimlet · 2 days agoRemix →