Ninja Star Tobacco Can
Created today
Description
What it's for
A round two-piece tobacco can with a raised eight-point ninja star on the lid and the brand "ORDINARY CAN OF TABACCER" embossed beneath it.
Dimensions
- Body: 76 mm diameter, 45 mm tall, 2 mm walls and floor
- Lid: 78 mm diameter, 10 mm tall, slip-fit over the body with about 0.2 mm clearance per side
- Star: 52 mm across, 2 mm raised
- Text: 1.5 mm raised
Remix ideas
- Swap the star for another emblem
- Make the can taller for pouches
- Add a knurled lid edge for grip
Images
More like this
Explore more in Storage & Organization →
Apothecary Box With Lift-Off Lid
A classic apothecary-style storage box, 6" x 4" x 2", with a separate lid whose inner lip plugs into the body. The two pieces are laid out side by side for viewing and print as two separate jobs, so each fits an 18 x 18 cm bed. Body: 152.4 x 101.6 x 47.5 mm, 2.4 mm walls, chamfered edges Lid: 152.4 x 101.6 mm, 3 mm plate with a 5 mm plug lip Fit: 0.3 mm clearance between lip and body recess Print the lid flat with the lip facing up, no supports needed
Four-Deck UNO Vault With Cap
A card-table caddy for four UNO variants: Classic, No Mercy, All Wild and Flip. Each deck lies flat in its own slot, split by 2 mm dividers, and a slip-over cap closes the box so nothing shuffles between slots. Slots sized from the supplied card dimensions plus clearance Walls 54 mm tall, so the tallest deck stays below the rim Finger hole through the floor of each slot to push decks up Front scoops for gripping Cap prints upside down and fits snugly over the outside of the rim
Petersson 95x155 v2 large
A 3 mm tall rim frame, 95 x 155 mm outside, with 3 mm thick walls and a triangular gusset in each corner. Each gusset has a 6.1 mm round pocket. Fit notes Outer size: 95 x 155 mm. Inner opening: 89 x 149 mm. Gussets: 16 mm legs, 3 mm thick, with a 6.1 mm pocket 2.1 mm deep. The -X wall has a 90 mm gap, centred along the 155 mm length. Check before printing Measure the opening you are mating to against 89 x 149 mm. This frame is not adjustable and does not fit anything with a different bore.
petersson liten bas
bas for box
peterson 80x95 v3
sdf
Petersson 95x80 v2
A 95 × 80 mm open-top tray, 50 mm tall, with 2 mm walls and a 2 mm floor. What it has 1.5 mm chamfers on the bottom edges and vertical corners; the top rim stays square. Four triangular corner gussets at the rim (z 47–50 mm), each with a 6.1 mm pocket 2.1 mm deep. A 44 mm long, 45 mm tall cut-out in the centre of the -X wall, leaving a 5 mm bottom lip. 13 vertical grooves (2 mm wide, 0.8 mm deep) on the outside of the +X wall. Check before printing The cut-out is 44 mm long so it stays clear of the gussets. Wider cut-outs would cut into them. Does not fit The earlier 155 mm length is gone; the tray is now 80 mm long.